Since I did not have the same materials and components as the 1st unit, the 2nd unit is slightly different although using the same "C" frame.
STEP-1.
2 sets of aircond compressor brackets are fixed together with self-drilling screws to form the "C" frame.
STEP-2
The swivel castors [1st unit have fixed non-swivel castors] were screwed to the base of the "C" frame and the exposed screw tip are then covered with hotmelt glue to prevent the sharp tips from hurting the user. All exposed screw tips are covered with the hotmelt glue.
STEP-3
Cross-bracing with 1mm thick Zincalume metal profiles [balance from a previous project] to connect the left and right "C" frames.
STEP-4
I did not have any more plywood for the table top. So use one of the shelf [30" length x 12" width] from an IKEA c.k.d shelf [extra after doing the kitchen cabinet].
VIEWS OF THE COMPLETED TABLE
Any one can DIY !
No comments:
Post a Comment